REMOTE CONTROL RUNNER
USER MANUAL
5
1. INTRODUCTION
The manual you have in your hands is a guide for the correct use of the RUNNER remote control. This
unit, together with the associated receiver, has been specifically designed for the wireless remote
control of electromechanically operated machinery.
The latest technology and modern microprocessors have been used in the electronic design. This
allows total safety in the use of the radio remote control.
The type of transmission used GCFI (Intelligent Frequency Change Management) provides the
equipment with an intelligent system that allows it to change to unoccupied frequencies in a random
and automatic way, thus avoiding interference that could cause continuous stops during operation.
2. GENERAL TERMS FOR THE CORRECT AND SAFE USE OF
RADIO REMOTE CONTROL
The user, in order to have the maximum security in the handling of the remote control, must follow the
rules described in this manual.
The operator of the remote control, when he has to perform any command of the device, must be
located in a place where he can visualize at all times the maneuver he is performing. If it
’s impossible
to do so, he must be located in a place where he can see the maximum possible maneuver, and in the
hidden places, an assistant is required. Never perform a maneuver that may have an uncontrolled
part.
Do not leave the radio remote control on the floor or on top of metal blocks but, if necessary, activate
the emergency stop (STOP BUTTON) on the transmitter.
When the operator of the remote control ends his working day or has to leave the remote control, he
must activate the emergency stop (STOP BUTTON) and place the battery in the charger for its
recharging.
2.1. KEYBOARD LOCKING PROCEDURE
Optionally, the device can have a keyboard lock/unlock system using a key sequence.
The remote control keyboard is locked by pressing the start button 5 times in less than 3 seconds, with
the STOP BUTTON pressed, which is indicated by the simultaneous lighting up of the LED
and the
LED
for 3 seconds.
To unlock the keyboard, press the start button again 5 times in less than 3 seconds with the STOP
BUTTON pressed. However, to confirm the unlocking, the two LEDs above blink three times.
Please note that if the start button is pressed when the keyboard is locked, the LED
and the LED
flash alternately.
