ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · info@ek.plus · www.ek.plus
CM COMPACT 8S4
USER MANUAL
FAQS
•
How many services can be installed on a MUX output?
It depends on the size of the channel selected in the
“P
rogram Pool
”
. For HD channels less
channels can be installed than for SD channels.
•
Why is the headend module not detected?
Plug the transformer into the power supply, and connect the output connector to the CM
COMPACT. Then connect a USB cable to the PC and open the CM MANAGEMENT program.
Press the USB button and it will be connected to the module.
•
Why is there no signal at the tuner input?
Check the orientation of the satellite dish and the LNB with the
•
If the MER (Modulation Error Rate) is located next to the power socket, can it be improved?
For installations where there are problems with the MER (Modulation Error Rate), an improved
performance of the product can be obtained, in the event that it has been attenuated at the
headend, leaving the attenuator at 0dB in the CM Management, and adding an external
attenuator at the headend output until the same attenuation is obtained.
•
How many input STREAMS can be added to the unit?
The unit allows for a maximum of 8 Streams.
•
How many output services can be added?
The permitted maximum is 56 services in total, between TV and Radio.
•
The following message is displayed:
•
Stream from pid extraction: no more channel available.
•
What needs to be done?
The unit allows for a maximum of 8 Streams. A stream must be removed in order to be
able to add another.
•
Is there a button to save the configuration?
The unit does not have any save button per se; it is saved automatically.
•
Can the configuration be exported and saved in a file on my PC?
Press the CM MANAGEMENT button and it will be saved in a file with the
‘.DTC’
extension.
