PS200 Configuration & Operation Guide
APPENDIX A-1 KEYPAD USE
Page 110
1 L
Æ
[ 1 0 0 ] G P M 0
F L O W A C T U A L 1 0 0 G P M
P U M P S P E E D 3 3 2 5 R P M
E N E R G Y S A V I N G S $ 1 3 2 5
REF
OPERATIONAL COMMANDS
Operational commands control the operation of the PS200 these include starting and stopping the PS200 and
adjusting the setpoint. The Setpoint value is used for controlling the process variable (speed, pressure, flow, level or
temperature).
Figure B - Operational commands of the keypad
Start
Stop
Reverse
(DISABLED)
Forward
(DISABLED)
Fault Reset
Function setting reference
Keypad/External Control
I
0
REF
RESET
LOC
REM
All operational commands such as start, stop and Setpoint can be given pressing the
appropriate key on the keypad when the control location is local. This is indicated by an
L (Local Control) in the upper left hand corner of the status row.
Remote control is indicated by an R in the upper left hand corner of the status row. This
indicates a start/stop command given by an external source such as 2 wire or 3 wire
start/stop. When in remote control the Setpoint can be changed from the keypad but
the start/stop commands must be given by the external source.
An empty field in the upper left hand corner of the status row indicates external control
from an overriding system such as a Digital Communication System. Operational
commands cannot be given from the keypad when in external control.
The control is changed between Local and External/Remote control by
pressing the LOC/REM key on the keypad.
SETTING THE SETPOINT VIA THE KEYPAD
Press the REF to enter the setpoint setting mode. A bracket appears in the
upper right corner of the status row. Use the double arrows for a fast change
of the setpoint and the single arrows for a slow change. Once the value is set,
press the enter key to enable it (the bracket disappears).
Note the Direction commands (
m o
) shown on the keypad have been
disabled in the PS200 to prevent inadvertent changes in rotation.
1 L
Æ
1 0 0 G P M 0
F L O W A C T U A L 1 0 0 G P M
P U M P S P E E D 3 3 2 5 R P M
E N E R G Y S A V I N G S $ 1 3 2 5
L - Local
R- Remote
O - Off
I - On
Summary of Contents for PumpSmart PS200
