V
05/11
OptiFlex 2 B
Start-up
17
Start-up
Preparation for start-up
Basic conditions
When starting up the OptiFlex 2 manual coating unit, the following
general conditions impacting the coating results must be taken into
consideration:
-
Manual coating equipment is set up properly
-
Gun control unit correctly connected
-
Gun correctly connected
-
Corresponding power and compressed air supply available
-
Powder preparation and powder quality
Set-up
The OptiFlex 2 B manual coating equipment should always be set up
vertically on a flat surface.
WARNING
The manual coating equipment must not under any circumstances
be set up near a heat source (such as an enameling furnace) or an
electromagnetic source (such as a control cabinet).
Summary of Contents for OptiFlex 2 B
Page 12: ......
Page 31: ...V 05 11 OptiFlex 2 B Initial start up 29 24 25 26 27 28 29 30 31 32 33 34 ...
Page 36: ......