V
05/11
OptiFlex 2 B
Initial start-up
23
Operation
Coating
1. Turn on the gun control unit with the
ON
key
The displays illuminate and the control unit is ready for operation
2. Swivel aside the fluidizing/suction unit
3. Place the open powder container on the vibrating table
4. Place the fluidizing/suction unit onto the powder
5. Set coating parameters:
6. Press the application button for the appropriate preset mode:
flat parts
complicated parts
overcoat
The arrow above the desired button lights up
OR
7. Press
program key
a) Select desired program (01-20)
b) Change coating parameters as required
Note:
Programs 01-20 are preset at the factory but can be modified at any
time, after which they are automatically stored.
Description
Presetting
Powder output
50%
Total air
4.0 Nm³/h
High voltage
80 kV
Spray current
80 µA
Electrode rinsing air
0.1 Nm³/h
Fluidizing air
0.1 Nm³/h (for OptiFlex-B and S)
Summary of Contents for OptiFlex 2 B
Page 12: ......
Page 31: ...V 05 11 OptiFlex 2 B Initial start up 29 24 25 26 27 28 29 30 31 32 33 34 ...
Page 36: ......