V
05/11
OptiFlex 2 B
Initial start-up
25
10. Setting the electrode rinsing air
a) Press the key
The second display level will be shown
b)
too much electrode rinsing air
11. Setting the fluidization
a) Press the key
The second display level will be shown
b)
c) Check the powder fluidization in the powder container
The powder fluidization in the powder containers depends on
the powder characteristics, the humidity and the ambient air
temperature. Fluidizing and vibration start by switching on
the control unit.
12. Point the gun into the booth (not at the object to be coated),
press the gun trigger and visually check the powder output
13. Check whether everything is functioning correctly
14. Coating
15. Adjust the coating parameters as necessary
16. Activate the rinsing function periodically
Note:
It prevents the bridging phenomena that can lead to short circuiting
when handling powders such as metallic powders.
In moist or tropical environments, any moisture is driven from the
injector, powder hose and powder gun.
a)
-
The LCD segments begin to move on the CG09 display
approx.
0.1 Nm³/h
approx.
0.5 Nm³/h
Summary of Contents for OptiFlex 2 B
Page 12: ......
Page 31: ...V 05 11 OptiFlex 2 B Initial start up 29 24 25 26 27 28 29 30 31 32 33 34 ...
Page 36: ......