V
05/11
32
Cleaning and maintenance
OptiFlex 2 B
Powder hose rinsing
If longer downtimes take place, the powder hose has to be cleaned.
Procedure:
1. Disconnect the powder hose from the hose connection on the
injector
2. Point the gun into the booth
3. Blow through the hose manually with a compressed air gun
4. Connect the powder hose again to the hose connection on the
injector
Cleaning
Cleaning the fluidizing/suction unit
1. Remove the injector
2. Remove
rinsing
module
3. Remove the fluidizing/suction unit
4. Clean the fluidizing/suction unit with compressed air. Also blow
off the suction tube with compressed air
5. Clean the injector (see therefore the injector user manual)
6. Clean
rinsing
module
7. Reassemble the individual parts
Cleaning the OptiFlex 2 GM03 manual powder
gun
Frequent cleaning of the gun helps to guarantee the coating quality.
Note:
Before cleaning the powder gun, switch off the control unit. The
compressed air used for cleaning must be free of oil and water!
Daily:
1. Blow off the outside of the gun and wipe, clean etc.
Weekly:
2. Remove the powder hose from the connection
3. Remove the spray nozzle from the gun and clean it
4. Blow out the gun from the connection in flow direction with
compressed air
5. Clean the integrated gun tube with the provided gun brush
6. Blow through the gun with compressed air again
7. Clean the powder hose
8. Reassemble the gun and connect it
Summary of Contents for OptiFlex 2 B
Page 12: ......
Page 31: ...V 05 11 OptiFlex 2 B Initial start up 29 24 25 26 27 28 29 30 31 32 33 34 ...
Page 36: ......