V 06/11
OptiFlex 2 C
Initial start-up
23
Operation
Coating
WARNING
If the manual equipment is not being used for coating in
conjunction with a sufficiently powerful suction unit, then the
stirred-up dust from the coating powder can cause respiratory
issues or cause a slippage/falling hazard.
- The manual equipment may only be operated in conjunction with a
sufficiently powerful suction unit (such as Gema Classic Open
booth).
1. Turn on the gun control unit with the
ON
key
The displays illuminate and the control unit is ready for operation
2. Fill in the desired powder quantity in the application cup
3. Carefully place the dip tube into the powder, in order to avoid the
clogging of the dip tube
4. Lock the bayonet closure
5. Set coating parameters:
6. Press the application button for the appropriate preset mode:
flat parts
complicated parts
overcoat
The arrow above the desired button lights up
OR
7. Press
program key
a) Select desired program (01-20)
b) Change coating parameters as required
Note:
Programs 01-20 are preset at the factory but can be modified at any
time, after which they are automatically stored.