10
5201229 Rev A
Chargemaster Pinner-LP
6. OPERATION
CAUTION! Electrical Shock Hazard
Do not touch Charging Bar during operation.
WARNING!
Fire Hazard
Do not operate equipment in close proximity to any flammable solvents or flammable
materials.
1. Before energizing any power supply:
• Ensure that all power supplies are properly grounded.
• Ensure that all charging bars have been properly located, positioned and installed.
• Ensure all requirements printed in the applicable power supply instructions have
been fully complied with.
2. After the above checks have been performed, simply energize each power supply to
operate the charging bars.
3. Setting Strength of Pinning:
• If charging bar is operating in electrical stress condition (evident by purple glow
on pins and slight sizzling noise), slowly decrease operating voltage of the power
supply.
• DO NOT exceed either the continuous or intermittent current ratings.
• If adhesion or pinning strength is not adequate, slowly increase operating voltage
of the power supply.
4. Always turn the power supply OFF when the system is not in use. For safety and ease
of operation, it is recommended to connect the power supply line cord to the electrical
system of the machine in such a manner that the power supply is only energized when
the machine is in operation.
NOTE:
Sustained operation in electrical stress will likely interfere with operation
of the charging system. Electrical stress reduces output voltage from the power
supply and suppresses the charging process. Sustained stressed operation may also
damage the bar and power supply.
