CleanIONVAC11_UM_9752073020_NL_D_GB_F _V1_0
32
GB
6. Installation
Warning:
- Electrical installation must only be carried out by a skilled electrical engineer.
- The
Clean
ION
must be properly earthed. Earthing is needed to ensure proper operation of
the equipment and to avoid electrical shocks upon contact.
- Disconnect the power supply before carrying out work on the unit.
6.1. Checks
-
Check that the Clean
ION
is undamaged and that you have received the correct version.
- Check that the details on the packing slip correspond to the details of the product received.
- Check that the voltage on the rating plate corresponds with the (mains) voltage that you are using.
If you have any problems and/or in the case of ambiguity, please contact SIMCO (Nederland) B.V. or
the agent in your region.
6.2. Installing the CleanION
Place the Clean
ION
in the desired position, close to the air line and connection cables for the ionisation
equipment. The surface must be stable and even. Position the dust collector so that the on/off switches
on the switchbox are easily accessible and the cover and filter can be removed easily.
The Clean
ION
can also be switched on and off via the machine to which the cleaning equipment is fitted.
6.3. Electrical installation
Thermal overload protection settings
1.3 kW 230/400 V 50 Hz 3.5 A
1.5 kW 230/400 V 60 Hz 3.8 A
Figure 2, electrical diagram of Clean
ION
- Connect the Clean
ION
connector cable to the switchbox on the machine or alternatively use a mains
plug. Observe the local safety regulations.
High-voltage jacks
High-voltage jacks
Motor
HIGH-VOLTAGE
TRANSFORMER
