Page 16 (52)
Ver 2_en_2022-06-27
Assembly Instructions
Envistar Flex
ivprodukt.docfactory.com
Order Portal
4.5
Lift with bracket EMMT-12, for 60 profile
00180
Follow the instructions for lifting in this manual.
Never exceed the specified weight for the respective lifting method or
lifting equipment.
Slide stops must be fitted when lifting, if bracket is used.
Replace used T-bolts and nuts with new ones after each lift.
•
•
•
•
A falling unit when lifting can cause crushing injuries.
Risk of serious crushing injury.
WARNING!
• The bracket does not fit the 50 profile.
• Load per lifting bracket ≤ 500 kg.
• Load if all four brackets are used ≤ 2000 kg.
• A safety factor of 2.0 has been utilised in static testing of the lifting
bracket.
• Use shackle with safety factor 6:1.
• Brackets must not be mounted downwards or sideways.
• Lifting brackets must not be mounted in the middle profile of double
stacked parts.
• Lift only one part at a time.
00098
1
3
2
Figure: Lifting bracket EMMT-12
1. Lifting bracket EMMT-12
2. Lifting lug
3. Fixing holes
EMMT-12 is delivered in a set of four.
1. Place the lifting brackets over the top four corners of the unit or unit part (on the longest
sides of the part), with the lifting lug upwards.
2. Insert the supplied T-bolts (MB 8×19 FZB 8.8), through the bracket and into the track in
the aluminium profile.
3. Turn the T-bolts, with a tightening torque of 24 Nm, so that they are at 90º to the profile
track and are firmly fixed under the edges of the track.
