PLEASE NOTE:
The screws provided with Iver
products are made from solid
brass. This allows finishes to be
matched as closely as possible
and prevents the possibility of
screws rusting in coastal areas.
Please note that screws require
pre-drilling
.
Please take extra care
when fitting.
IMPORTANT:
Please install this door
hardware in the following
order to ensure its warranty
is not voided.
1.
Install the door hardware
on raw / unfinished door
using the instructions
provided.
2.
Remove door hardware
and store safely. Do not
place painters tape or
masking tape over the
product. The tape will
damage the finish.
3.
Paint / finish door.
4.
Reinstall hardware.
Please recycle
me after use
4
Sliding Door Pull
—
With Euro Lock
Function
7.1. Using preferred method create a W25mmxH42.5mm
cavity to a minimum depth of 20mm on the door edge.
7. Preparing the Door
(5)
7.2. Remove dust and insert dustbox.
7.3. Place edge pull over cavity and mark around the
edges with a Stanley knife.
7.4. Using your preferred method create a 3mm recess
to accommodate face plate.
(4)
8.1. Insert the edge pull face plate.
8. Installing Edge Pull
8.2. Drill two 2mm pilot holes for face plate screws at
6 and 12 o’clock and Install screws.
8.3. Tighten manually with a screwdriver.
(6)
(4)
(5)
Edge Pull
