PLEASE NOTE:
The screws provided with Iver products are made from
solid brass. This allows fi nishes to be matched as closely
as possible and prevents the possibility of screws rusting in
coastal areas. Please note that screws require
pre-drilling
.
Please take extra care when fi tting.
Backplate Entrance Set
Not Included
6.1.
Insert thumb turn euro cylinder through the lock body and fi x
with the appropriately sized cylinder screw provided.
—
*If required, refer to suppliers instructions.
6. Install Euro Cylinder (Thumb Turn)
1.
2.
Included
5.1.
Place the split spindles into the lock body from
either side of the door*.
5. Install Levers
5.2.
Install the halves on either side of the door, ensuring
the levers function in the correct direction.
5.3.
Insert male tie bolts through top and bottom of back
plate,
OR
5.4.
Affi
x wood screws at all fi xing points.
5.5.
Place the female sections in the opposite holes,
lining them up with the male thread.
(Figure 6)
5.6.
Secure loosely by hand, then use a screwdriver to
hold the female section while tightening the male
section with a second screwdriver.
—
* Regular spindle also provided
Figure 6.
(1)
(5)
(2)
Wood Screws
(4)
5. (or 4.)
1. Backplate
Entrance Lever Set
5. Tie Bolts
4. Wood Screws
2. Split Spindle
3. Standard
Spindle
