1.1.
This is the distance from the middle of the top
fixing point to the middle of the bottom fixing
point. If unsure, this measurement can be found
in the product description on the box and in the
specifications on our website. (Figure 1)
1. Determine the Centre to Centre
(CTC) measurement of your
pull handle
2.1.
Mark the top fixing point on the face of your door
at the desired height and horizontal distance from
door edge.
2.2.
In most instances, the horizontal position should
align with the centre of the door stile on a panel
door or with any lock, turn or escutcheon fitted to
the door. (Figure 2)
2.3.
Using a spirit level, mark the bottom fixing point
— noting the CTC measurement. (Figure 3)
2. Marking the Door
Preferred product height
Figure 3.
Figure 2.
Figure 4.
Figure 5.
Figure 1.
3.1.
Remove the taylor spindles from the pull handle by
loosening the grub screws. (Figure 4)
3. Fitting the Pull Handle
(Concealed Fix Method)
3.2.
Centre one of the taylor spindles on the top fixing
hole and using a pencil, mark the three wood screw
holes. Repeat for the bottom fixing point.
3.3.
Drill 2mm pilot holes for the wood screws at each of
the six marks and affix the taylor spindles to the door
with wood screws provided. (Figure 3)
3.4.
Place pull handle on taylor spindles and tighten both
grub screws to secure.
(1)
(2)
(4)
(2)
(5)
IMPORTANT:
Please install this door hardware in the following
order to ensure its warranty is not voided.
1.
Install the door hardware on raw / unfinished door
using the instructions provided.
2.
Remove door hardware and store safely. Do not place
painters tape or masking tape over the product. The
tape will damage the finish.
3.
Paint / finish door.
4.
Reinstall hardware.
Please recycle me after use
