STEP 4
STEP 5
Connect Thigh Supports (1) to Handle (3)
1. Insert Thumb Screws (2) into slots in Handle.
2. Raise Thigh Supports and thread
Thumb Screws into the nuts located
on underside of Thigh Supports.
3. Do not fully tighten. Ensure that
Thigh Supports can rotate on tubes.
When threading the nut, PUSH DOWN LIGHTLY to prevent pushing the
nut out of the socket.
If Thumb Screw will not tighten, confirm that the nut on underside of
Thigh Support is in place. If missing, check your work area to see if it has been
accidentally pushed out.
If nut is missing, do not panic. Nut is standard M5 x .8, available at most
hardware stores, or call us for replacement.
Push ends of tubes to
align Support Tube holes
with holes in Clamp.
Insert Clamp Bolt (8a)
and thread onto Clamp
Nut (8b). Do not tighten
yet.
Clamp (8) should be
centered between ends
of Support Tubes (8)
and centered on slot as
shown. If necessary, use
screwdriver or similar
to rotate Clamp (8) into
position.
THUMB
SCREW
THIGH SUPPORT
NUT
Assembly
6
LEARN FASTER! View INSTRUCTIONAL VIDEOS instead!
www.iwalk-free.com/help
Summary of Contents for iWALK 2.0
Page 1: ......
