Mounting Location
• Avoid installation in direct sunlight or strong ultraviolet light
• Avoid installation over heat generating devices and/or in moist areas
• The product should not be mounted near electronics that emit radio
frequencies or electromagnetic interference (such as CRT monitors, light
dimmers, and some power supplies).
• Do not mount the iWalldock outdoors or in areas exceeding the operating
temperature range of 65° to 85°F
Powering/Charging
• The USB power connection that charges the iPad® can be extended using
standard USB extension cables at most 6’ + Apple Lightning charging cable.
Beyond this length, the iPad® will not receive full charging power and may
discharge with use over time.
• If the installation requires extending USB power greater than 6’, use the
iWalldock Long-Distance Charger, available at www.iwalldock.com. This
product allows full-power USB charging up to 165 ft distance using 16/2 in-wall
speaker wire, or 100 ft using two or more pairs of conductors of Cat5e/6.
Disclaimer
• This product should be installed by a professional contractor
• Follow all local/regional/national electrical codes
• No warranties expressed or implied
iPad® is a registered trademark of Apple, Inc.
All rights reserved.
Steps for Installation:
1. Determine location. Typical touchscreen height is 56”-60” to the bottom
of the screen. Wall material should be smooth and flat (drywall, wood or
paneling). Minimum material depth is 1/2”
2. Use a level to draw a horizontal line approximately 6” long at the desired
height, then use the supplied iWalldock template to trace the cutout onto
the wall using the level line as a guide
3. Using the appropriate cutting tool, follow the line to cut out the hole.
Gently test fit the iWalldock to ensure a gap-free fit. It may be necessary
to remove excess material around the cutout to ensure iWalldock rests flat
against wall surface
4. If the wall is hollow behind the cutout, you will need to use the (2)
provided clamps to secure the iWalldock. If a stud aligns with the
mounting holes in the iWalldock, you may use these instead of the clamps.
If there are obstacles inside the wall, use alternate mounting holes as
needed to provide the best possible installation
5. Arrange the clamps on the back of the iWalldock and partially insert the
provided screws. Push the clamps away from the iWalldock as far as
possible to provide a gap which will eventually clamp the wall material
6. Connect in-wall USB charging solution to Apple Lightning cable and push
Lightning connector through the small opening in backside of iWalldock.
Leave just enough cable that it can be easily plugged-in, but not so much
that it is difficult to tuck cable into wall after it is connected
7. Insert iWalldock into the wall opening and slide downward until clamps
clear the top of the opening. Then slide iWalldock into place and slowly
and gently tighten screws until clamps pulls tight against the backside of
the wall material. If using stud(s) to mount, screw these in now. DO NOT
OVERTIGHTEN!
8. Plug iPad® into exposed Lightning cable and gently push iPad® toward
cable opening until the iPad® is fully inserted, then push iPad® flush into
iWalldock.
9. If the iPad® must be removed, use the provided suction cup opposite of
the Home button to gently pull out on the iPad® until you can pull it out
of the dock. Be careful not to lose the charging cable inside the wall.
