Compressor turns on and off while airbrush is not spraying air.
The compressor has an air leak somewhere. When this happens, try the following steps:
1. Spray all connections with a soapy water solution.
2. Bubbles indicate an air leak.
3. Tighten connection.
4. If bubbling doesn’t stop, try wrapping threads with thread sealant tape (max 3 wraps only) or applying beeswax to the threads.
Both methods provide an airtight seal.
5. If the air leak is in the middle of a hose the hose will need to be replaced.
For any other problems or issues call or contact ANEST IWATA-MEDEA at 503-253-7308 or email at: info@iwata-medea.com
TROUBLESHOOTING
10
Summary of Contents for IS-875HT
Page 2: ......
Page 12: ...Rev2 9 16 w w w I W A T A A I R B R U S H c o m...
