Iwata MAXX JET IS-1000, Manual

Unpack the compressor and all packaged components. Enclosed you will find:
•  Maxx Jet Compressor
•  Black vinyl connector air hose (compressor to regulator)
•  Two (2) airbrush hoses (regulator to airbrush)
•  One (1) airbrush holder
•  One (1) spray gun holder
•  One (1) dual manifold air regulator and gauge
•  One (1) power cord

Set Up
1.     Remove top lid off compressor exposing top accessory tray.

2.  Attach the power cord to the unit near the base of the retractable handle.

3.  Screw one end of the black vinyl connector air hose onto the air outlet above the on/off switch.

4.  Screw the other end of the black vinyl connector air hose onto the air regulator input.

5.  Mount the air regulator on the edge of accessory compartment by sliding it onto the edge. Do the same with the airbrush holder  
 

and spray gun holder.

6.  Take the airbrush hose (air hose with small fitting on one end and large fitting on the other) and screw the large fitting onto the air regulator  
 

output. (There are 2 outputs. Choose one.)

7.   To use the optional second output, remove the protective cap from the second output of the air regulator.

8.  Take the spray gun hose (large fittings on both ends) and screw one end to the second output on the air regulator.

9.  Now you can screw your Iwata airbrush onto the airbrush hose and your Iwata G-3, G-5, G-6 or RG-3 onto the spray gun hose.

GETTING STARTED

8