Iwata MAXX JET IS-1000, Manual

10.  Place your airbrush on the airbrush holder and your spray gun onto the spray gun holder.

11.  Plug the compressor into a grounded wall outlet. (Avoid using an extension cord.)

12.  Turn the compressor ON by pressing down the on/off switch back of the unit.  (You will see the button light up.)
 

A. The Maxx Jet will run until its storage tank fills up, then stop. As you run your airbrush, the stored air will deplete. At a certain point    

     the Maxx Jet will turn itself on to replenish the stored air.

Using The Compressor
1.   Turn compressor on by pressing the power button.
 

* You will see the button light up. If there is no air in the air tank then the compressor engine will turn on and fill up the tank.

2.   To adjust the air pressure, pull up on the black knob to unlock it.
 

A. Twist clockwise to raise the pressure.

B. Twist counter-clockwise to lower the pressure.

Note: There’s a + and - sign on top of the knob with arrows to remind you which direction raises and lowers pressure.

3.   After you’ve obtained the desired pressure, push down on the knob to lock it in place.
 

Note: The regulators come from the factory set at 100psi. (Keep twisting counter-clockwise until the gauge starts to move.)

4.   While using the compressor, you’ll notice moisture start to condense in the clear plastic bowl of the moisture trap on the air regulator.

5.   When droplets start to form in the trap, simply press up on the pressure release valve underneath the clear plastic bowl to release the built  
 

up moisture. 

Note: How often you need to do this will vary based on the weather and how much humidity is in the air.

6.   When the airbrush or spray gun is not in use it may be placed in the appropriate holder.

GETTING STARTED (CONT’D)

9