14
The procedure is as follows:
1.
Recharge CAERBERUS completely, using the battery charger
supplied with the product (see specific chapter in the manu-
al).
2.
Screw the torch head connector onto the Canister.
3.
Sink the torch head in water.
4.
Turn the product on in MAX mode and leave the product in
the water to discharge in accordance with the times indicat-
ed in the table below:
TYPE OF TORCH
TYPE OF CANISTER
DISCHARGE TIMES
CAERBERUS
Canister 10Ah
90 minutes
Canister 15Ah
110 minutes
CAERBERUS S and CAVE
Canister 10Ah
70 minutes
Canister 15Ah
90 minutes
5.
Switch the product off after the indicated discharge times.
6.
Dry CAERBERUS, unscrew the torch head connector and re-
place the components in storage.
7.
By following this procedure, the battery will contain approxi-
mately 50 - 60% of its charge and by decoupling the torch
head and Canister, the battery will be isolated from the cir-
cuit, preventing any further reductions of the energy stored in
the same.
Two complete recharging and discharging cycles, followed by the
“storage procedure”, should be carried out every two months of
inactivity.
Summary of Contents for Caerberus
Page 1: ...www iwavedesign com ...
Page 15: ...15 www iwavedesign com ...
