Remove and Insert Power Supply Module
The power supply module is accessible after removing the rear cover. For details see the
To remove the rear cover, unfasten the four screws around the cover and pull out the cover.
To remove the power supply module:
1. Loosen the thumbscrew in the upper left corner of the power supply module.
2. Pull the power clamp handles.
3. Hold the two handles provided on the power supply module and pull them.
To remove the individual power supplies:
1. Hold the handle on the power supply
2. Pull the clip inwards and then pull the handle out.
Individual Power Supply Removal
To insert the individual power supplies, slide the power supply in until you hear the clicking sound of
the clip.
To insert the power supply module:
1. Place the power supply module on the bottom chassis rails as shown in the image below.
2. Push the power supply module inwards.
Chapter 3 Install XGS12 Chassis
– 10 –
