The GridBee utilizes high efficient brushless
motor technology which enhance its performance
through more efficient and durable components,
as well as easy component access, and a more
robust frame structure.
Electronics
Electrical Control Box -
The electrical control
box is located on the exterior of the tank /
reservoir. The electrical control box converts
110VAC power to a clean 45VDC power source
which then operates the motor controller. The
control box also consists of a ground fault
interupter (GFI) switch to aid in protection of faulty
circuits or shorting of circuits. A durable 316SS
Cord Grip is used to handle all weather elements,
protecting the penetration of the electrical cable to
the motor controller on the inside of the tank.
Motor Controller
- The motor controller is located
near the motor just below the top plate of the
Gridbee. The motor controller is sealed in line
with the electrical cord that runs to the brushless
motor.
The motor controller on the GridBee receives
power from the electronic control box located on
the exterior of the tank. This power is delivered
as 45VDC which is used to operate the brushless
motor at the commanded speed.
Due to the high frequency of communication
between the motor controller and brushless motor,
the two components need to be located close
to one another. This is the primary reason for
having the motor controller located directly on the
GridBee.
Electronic Control Box of an
Underground Reservoir
Motor Control Cord
©2021 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | watercare@ixom.com
Features
Features
GF1250PWc
10289_20210806
O&M_GF1250PWc_10110_20210922 - 8
