Technology Description-
Floating, electric powered, circulation and Trihalomethane (THM) removal equipment for po-
table water tanks and reservoirs. Designed for continuous operation and factory installed through 24-inch diameter, clear
and unobstructed hatch opening.
Figure 1:
SN10
Electrical Requirements -
Requires 240VAC/3PH or 480VAC/3PH, 60Hz power. Ixom recommends secondary
disconnect to be located near equipment access hatch. Optional Franklin SubMonitor three-phase motor protection unit
highly recommended and available from Ixom.
All switches, breakers, emergency stop buttons, control panels and other
controls shall be installed in accordance to all NEC, State, and local regulations.
(Not supplied by Ixom)
Patent Pending
Subject to change without notice.
Certifications
- Ixom's potable water products are certified to ANSI/NSF Standard 61, and 372 for lead-free content.
Learn more at: www.medoraco.com/std61
Maintenance / Warranty
- Limited maintenance. Limited 2-year parts and labor warranty. See Warranty Statement for
details.
Spray Unit Direct Flow Rate
- 0.90 million gallons per day,
MGD.
Ixom application engineering evaluations often require
sizing systems based on site specific conditions and NOT
the spray aeration direct flow rate.
Minimum Water Depth
- Minimum of 5ft (1.5m) operating
depth required,
do not operate out of water. Minimum of
6.25ft (1.9m) depth required with leg extensions.
Minimum Head Space
- Minimum of 30in (76cm) head
space between water level and reservoir/tank ceiling
required.
(Contact Ixom for exceptions that can be
made.)
Sealed Penetration Fitting -
T316 stainless steel tank fitting with a 3/4” NPT female connection. Not designed
as a submersible penetration.
Wiring -
4-conductor, submersible power cable for submersible motor wiring terminated exterior at top of tank.
Motor -
10HP stainless steel submersible, designed for continuous operation, low power requirement, direct drive,
no gearbox and no lubrication schedule required. See certifications section below.
Materials of Construction
- T316 stainless steel,
thermoplastic rubber, high density polyethylene construction.
GridBee
®
machines are constructed using safe materials for
contact with potable water. See certifications section below.
TTHM Reduction Range
- 20% to 70%, dependant on
THM species, daily inflow and other variables, see Ixom for
proposal.
Minimum Access Opening
- Machine can be placed
through 24-inch (61cm) diameter, clear and unobstructed
hatch opening.
Intake -
20 to 100+ feet (6 to 30+ m) available in 12-inch (30.5 cm) diameter X 20 feet (6 m) sections, thermoplastic
rubber, NSF/ANSI 61 approved. Includes low elevation intake that draws water in a horizontal layer within 18 inches
(45 cm) of the tank or reservoir floor. Includes intake retrieval chain constructed of 316 stainless steel.
Shipping Size / Weight
• Crate -
72in x 48in x 59in (1.85m x 1.22m x 1.5m) / 1200lbs (550kg)
Exact weight and dimensions varies dependent
on machine configuration.
132”
36”
30”
75”
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | info@medoraco.com
Technical Data Sheet
SN10
1554_10016_20201006
O&M_SN10_10030_10104_20201006 - 10
