105
105
105
105
!
DIG I/O ROUTING
Shortcut keys:
!
Session Controller
SHIFT+DIG IN(ROUTE)
!
KC-24 Keyboard
N/A
This menu has two sub-menu selections:
!
2-CH I/O ROUTING
Here you can independently assign the ins and outs of the 2-channel digital I/O to tracks 1 through 24.
!
MULTI-CH IN TRKS
This dialog allows you to select either analog or digital inputs for each track using the track arming keys.
DIG I/O SDQ
SDQ is an acronym for Single, Dual, and Quad wire. It refers to the way RADAR
24 handles high sample
rate digital audio going to and from external sources via the AES multi-channel I/O. The choices in this
menu will vary depending on the sample rate of the current project. At a sample rate of 192 kHz the
selections will be:
!
SINGLE
!
DUAL
!
QUAD
It is important to select the appropriate SDQ setting so that RADAR
24 will display and reproduce the
recorded audio correctly.
IMPORTANT NOTE: Projects being recorded at 192 kHz using dual and quad wire AES
multi-channel digital audio cannot be monitored directly using the RADAR
24’s analog
outputs. Once the audio is recorded however the project can be played back using the
analog outputs by selecting an SDQ setting of
SINGLE
.
Note: This only applies when recording from external dual and quad wire AES sources at 192 kHz.
DIG IN L: 00 R:00
OUT L: 00 R:00
DIG IN TRACKS:
ALL
SELECT
DIG I/O SDQ 192K:
SINGLE DUAL QUAD
