14
tap to the mains water option remembering to turn on the water tap (fig. 11,
tab.1), as shown below.
NOTE
It is recommended to use filters to reduce the build up of limescale.
Make sure that the tap located under the drip tray, (fig. 11, tab. 1) is
in the appropriate position. If this check is not carried out, and the
tap is in the opposite water filling position, the pump could break (check the
adhesive label located near the tap, see image below).
IMPORTANT:
Lack of water can cause damage to the pump and the resistor.
Therefore, if the pump makes a noise that is different to usual when in
use and, at the same time, the pressure gauge reads a lower pressure level,
the machine must be immediately turned off using the specific button
(fig. 13, tab.1).
