16
November 5, 2015
3. Insert entirely the roll formed end into the stove collar and
screwing it with a minimum of 3 screws.
WARNING: It is mandatory to attach the pipe to the
stove collar and also at each joint with at least of 3
screws.
4. Install all the next section up to the chimney support collar
and be sure to attach all parts with at least 3 screws.
ATTENTION: It is OBLIGATORY to attach the pipe on
the stove flue collar and each joint with at least 3
screws.
5. Install all other parts and attach them up to the chimney
collar.
6. Attach the connection pipe with 3 screws.
DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY
SERVING ANOTHER APPLIANCE.
CONNECTOR PIPES SHOULD NEVER GO ACROSS A
CEILING, A WALL, A CLOSET, AN ATTIC OR OTHER
ENCLOSED AREA THAT COULD CAUSE HEAT
BUILDUP. IF YOU NEED TO PASS THROUGH
COMBUSTIBLE MATERIAL, MAKE SURE THAT YOUR
INSTALLATION COMPLIES WITH CAN / CSA-B365.
Installation in a mobile home
DO NOT INSTALL THIS APPLIANCE IN A
MOBILE HOME.
