24
March 1
st
, 2015
Operating Instructions
Primary and secondary air admission
control.
When the handle on the left side of the stove is vertical the air
admission is from the tube only, this is what we called
“Secondary air admission”. Else when the handle is horizontal
the air admission is direct and from the top of the door opening,
this is what we called “Primary air Admission”
Warning: Operate stove with the Primary air admission
fully open for a long period of time, can damage the stove.
IS PROHIBITED TO MODIFY AIR ADMISSION TO OBTAIN A
BRIGHT FIRE OR FOR ANY OTHER REASON.
MODIFICATION CAN AVOID GUARANTEE.
Lightning fire.
After installing correctly the stove following the installation
instruction of the manufacturer, you are ready to light it.
1) Turn the admission handle in horizontal position to set
the primary air admission.
2) Be sure to close all cooking holes
3) Turn the deviation knob in the non-cooking position
4) Put paper and lightning wood into the combustion
chamber like your preferred disposition and light it
5) Close partially the door keeping a slight opening.
When chimney have enough heat buildup close
completely the door and lock it. Wait for a good fire
buildup.
6) Once you have an ember fire, it’s time to add logs.
Follow now the instruction section on how to keep a
fire
DO NOT OVER CHARGE THE STOVE OVER THE
UPPER BRICK ROW
You can control the combustion by turning up or down the
handle. The wood will burn more rapidly when more primary air
is set. Otherwise the wood burn more slowly and more
efficiently with the handle set to secondary air. You can
balance the primary and secondary air to have more heat, to
cook.
Warning: Operate stove with the Primary air admission
fully open for a long period of time, can damage the stove.
NEVER LEAVE THE STOVE UNATTENDED WHEN THE
DOOR IS SIGHTLY OPEN. ALWAYS CLOSE THE DOOR
AFTER LIGHTNING.
CAUTION: NEVER USE GAZOLINE, GAZOLINE TYPE
LANTERN FUEL, KEROSEN, CHARCOAL LIGHTER FLUID,
OR SIMILAR LIQUIDS TO START OR “FRESHEN UP “A
FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL
AWAY FROM THE HEATER WHILE IT IS USE..
First fire.
The first hours of operation, you must heat it gradually. In order
to allow an appropriate cooking of the paint and in order to
facilitate its adhesion with metal, do not heat the appliance with
a strong fire. It will also avoid thermal shock which could lift up
the paint or make it whiten.
Make sure that the room is ventilated enough in order to
eliminate the odours and the smoke coming from the paint
during the first hours of utilization. It is normal that a light
smoke is released from the paint during the first hours of use.
Even if this nuisance is temporary, open the windows and the
doors in order to ensure a good ventilation. This special paint is
conceived to tolerate temperatures until 1200°F (650°C).
Keep a fire.
To add firewood into the stove and keep a fire.
5) Turn the handle to horizontal position and wait a few
second to let the fire adjusting to the new conditions..
6) Open the door handle to the first position and wait a few
second to balance pressure to avoid fume to escape from
stove
7) Wide open slowly the door.
8) Move embers with poker near to the door to oxygen it and
make it burned completely
9) Add firewood over the ember, keeping it away from the
glass door to avoid flame touching the ceramic glass.
DO NOT BUILD A FIRE TOO CLOSE OF THE WINDOW.
10) Close the door slightly and wait to be sure the wood is
burning.
11) One the wood is burning close and lock the door.
12) Adjust the air admission handle to needed setting.
NEVER LEAVE THE STOVE UNATTENDED WHEN THE
DOOR IS SIGHTLY OPEN. ALWAYS CLOSE THE DOOR
AFTER ADDING A LOAD.
CAUTION: NEVER USE GAZOLINE, GAZOLINE TYPE
LANTERN FUEL, KEROSEN, CHARCOAL LIGHTER FLUID,
OR SIMILAR LIQUIDS TO START OR “FRESHEN UP “A
FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL
AWAY FROM THE HEATER WHILE IT IS USE.
Fans Controls.
The switch on the snap disc box is only to power up and down
the fan
On power up position the fan is control by a snap disc factory
set to 120 Fahrenheit (49 ° Celsius)
On Off Position all the fans shut down.
NEVER ROUTE THE ELECTRIC WIRE OF FANS IN FRONT
OR UNDER APPLIANCE
