PR_I020/2023-08-11-EN
Revision: 5
32
Installation of the optional 460 CFMs second blower (part #: V)
Adjustment of the fan speed
Step 1 :
Remove the bottom right
plate. Push on one side of the
plate to tilt it. Keep twisting the
plate until it comes apart.
Step 2
: If it’s not already done,
remove the access panel
(B)
on
the back of the appliance by
unscrewing / untightening the 3
screws
(A).
Insert the 4 bolts
(C)
with their screwing part oriented
downward at the designated
location in the adjacent picture.
Put them inside the fan housing
by
passing the hand
through the
access opening. Put the second
blower in the opposite orientation
compared to the first blower.
Screw the fan to the stove with the
4 lock washers
(D)
and the 4 nuts
(E)
provided with the fan kit
.
Connect the power supply of the
second blower to the electric outlet
of the first blower
(G).
Put back the
access hatch
(B)
in place.
It is possible to change the speed
of the blower(s) in between the
high and the low speed. The
position of the switch(es) as
shown in the adjacent picture (J)
should correspond to the low
speed configuration.
Note:
There is no off position on
the switch(es).
Summary of Contents for ULTIMATE TOR 2015
Page 4: ...PR_I020 2023 08 11 EN Revision 5 4 Rating plate...
Page 5: ...PR_I020 2023 08 11 EN Revision 5 5 Appliance Dimension...
Page 13: ...PR_I020 2023 08 11 EN Revision 5 13 Firebox configuration and part list...
Page 28: ...PR_I020 2023 08 11 EN Revision 5 28 Annex 1 Door assembly Square Door Arc Door...
