EN
104
AUXILIARY HANDLE
The auxiliary handle can be attached to
the auxiliary handle connector
6
on either
side or the top of the tool.
1
Screw the auxiliary handle into the ap-
propriate auxiliary handle connector
6
.
2
Using the Tool
1.
Make sure your workpiece can not slip and
hold the tool firmly at the main handle
1
and
auxiliary handle
4
.
2.
To switch on the tool, push the small lever
forward and then press the on / off switch
3
.
The tool will then be in lock on position.
3.
Let the tool run at no-load speed for
about a minute and check if the in-
stalled wheel runs flawlessly.
Grinding:
The best grinding results can be
achieved with a 30° to 40° ap-
proach angle. Move the tool back and
forth with moderate pressure.
4.
To switch off the tool, press and release the
on / off switch
3
.
Intended Use
The tool is intended for roughing and grinding of
metal and stone materials without the use of wa-
ter when equipped with a suitable grinding disc
and the appropriate guard.
For cutting the material mentioned above, a spe-
cial cutting guard (accessory) must be installed.
Any other use or modification to the tool is consid-
ered as improper use and could cause consider-
able dangers.
Warning!
Make sure the tool is
switched off and unplugged.
Warning!
For safe working conditions,
make sure the auxiliary handle is al-
ways mounted at the tool.
Product Overview
1
Main handle
2
Supply cord
3
On / Off switch
4
Auxiliary handle
5
Grinding guard
6
Auxiliary handle connector (3x)
7
Spindle lock button
8
Guard lock lever
9
Lower flange
10
Lock nut
Summary of Contents for JWS 2400PA
