M
AINTENANCE
Application area
Operating material
Motor lubrication
JDN high performance
grease, item no. 11904
(250ml)
Engine lubrication for
operation with oiler
Air lubricator “D”, kine-
matic viscosity about
30
mm
2
s
(cSt) bei 40
◦
C,
possibly with anti-icing
agent
Chain lubrication
Chain oil or vehi-
cle motor oil, kine-
matic viscosity
about150
mm
2
s
(cSt)
at 40
◦
C, or special
lubricant from J.D.
Neuhaus.
In areas with extreme
corrosion potential,
such as offshore, a
lubricant with a particu-
larly powerful corrosion
protection is to be
used.
Engine corrosion pro-
tection (not applicable
if using the JDN high
performance grease)
Non-gumming preser-
vative oil with corre-
sponding effective
duration
Engine cleaning (not
applicable if using the
JDN high performance
grease)
Pure petroleum
Lubrication for bearings
and gearbox (also for
open gears)
Lithium-saponified
grease, worked pen-
etration 265-295
(0,1mm), base oil
viscosity: 190
mm
2
s
(cSt)
bei 40
◦
C, dropping
point: 180
◦
C,
Application temper-
atures: -20
◦
C bis +
120
◦
C,
Designation according
to DIN 51825: KP2K-
20, active ingredients:
EP additives (to reduce
wear) and ageing pro-
tection; water-resistant
and anti-corrosive
8.6.2. Lubricating the chain
Before tests can be carried out, the chain must be
lubricated.
The chain of your product
PROFI 25 TI
must be
lubricated in the links in an unloaded state.
I
Clean heavily soiled chains.
I
Place the chain in a suitable container.
I
Spray the chain with a special lubricant or ve-
hicle engine oil.
If you want to lubricate the suspended chain, en-
sure that the chain links are oiled at the contact
points. Move the chain back and forth to do this.
During operation in areas with a high corrosion po-
tential, such as offshore, the chain can be largely
protected against corrosion by using speciality
lubricants. These types of lubricants are char-
acterised, among other things, by a weathering
resistance, water insolubility and good adhesion
properties.
The re-lubrication intervals are to be set depend-
ing on the exposure. Please contact us if neces-
sary.
Doc.-No.: VA049318-10-OM-EN-0319-64-2
Page
47
of 64
