I N I T I A L O P E R AT I O N
Page 25
Check air connection for contamination and clean if
necessary.
Blow through compressed air hose in order to remove
foreign bodies.
Attach the compressed air hose to the connection on
the hoist housing. Tighten the union nut.
The following lubricants are intended for normal
environmental influences.
In the case of wear-promoting environmental influences,
please contact J.D. NEUHAUS, to receive the appropriate
instructions.
C AU T I O N !
Oils and greases can cause skin irritation.
Wear protective gloves.
AT T E N T I O N !
Potential motor damage! Do not mix synthe-
tic oils with mineral oils, as the physical and
thermal properties may be impaired.
Synthetic lubricants must not be used when
operating with oilers.
Alcohols are not permitted for use as anti-
icing agents.
Attach the compressed air hose and tighten
the union nut.
L U B R I C A N T S
C O N N E C T I N G T O T H E M A I N A I R S U P P LY
Application
Consumable
Motor lubrication
- JDN high-performance
grease,
- from factory
Art. no. 11901 (1 kg)
Art. no. 11902 (40 g)
- when operating with oiler
- Compressed air oil "D",
kinematic viscosity
approx. 30 mm
2
/s (cSt)
at 40°C, with anti-icing
agent where applicable
Chain lubrication
Automobile motor oil,
kinematic viscosity
approx. 150 mm
2
/s (cSt)
at 40°C, or special
lubricant from J.D. NEUHAUS
Motor conservation
Non resinous
(not applicable when using
Conservation oil with
JDN high-performance grease) appropriate
period of effectiveness
Motor cleaning
Pure petroleum
(not applicable when using
JDN high-performance grease)
Lubrication of bearings
Lithium-thickened grease,
and gearbox (also for
worked penetration 265-295
exposed gears)
(0.1mm), basic oil viscosity:
190 cSt (mm
2
/s) at 40°C,
drop point: 180°C,
Working temperatures:
-30°C to +120°C,
designation according to
DIN 51825: KP2K-30, active
agents: EP additives (for
wear- reduction) and ageing
protection; water resistant
and corrosion protection
