P
RODUCT INFORMATION
Definition of oblique pulling (
,
→
Figure 1)
Figure 1: Oblique pulling
Oblique pulling is the deviation from the vertical
position of the load chain and the chain hoist in
the straight course of the force line between the
point of application of force of the load on the load
hook and the suspension on the carrying structure
(
α
6
= 0
◦
).
Using special safety precautions that are ap-
propriate for the respective situation, your prod-
uct
PROFI 3 TI
can be used for diagonal pull. In
the process, a chain box may not be used, as
the chain could fall out here or become knotted.
Please contact us if necessary.
For other foreseeable misuses:
,
→
Rules for safe operation
, page 33
Your product
PROFI 3 TI
may not be used in the
following areas:
•
critical areas in nuclear plants
•
over acid baths or systems with aggressive
substances
•
in areas where there are organic acids
•
in areas outside of the permissible ambient
temperatures
3.3. Labelling (nameplate)
You will find a nameplate on your product
PROFI 3
TI
for an exact identification.
The nameplate of the product PROFI 3 TI (Figure
2) with all of the important information is located
on the housing cover of the hoist motor.
Figure 2: Nameplate PROFI 3 TI
Page
12
of 60
Doc.-No.: VA053957-40-OM-EN-0720-60-2
