P
RODUCT INFORMATION
Figure 6: Lifting limiter
3.5.9. Lowering limiter
WARNING
Danger from chain fracture
If the buffer is damaged, unacceptably high loads
may act on the chain when starting the lowering
limiter. The chain may break.
I
Do not use product
I
Have product repaired (replace buffer)
NOTICE
The lowering limiter may only be started in cases
of emergency. The operator must monitor the load
hook movement and stop the lowering movement
in due time. Striking the buffer against the housing
is to be avoided. This may result in damage to the
buffers.
Your product is equipped with a limiter that stops
the lowering movement (
,
→
Figure 7).
In order to achieve this, a buffer
(1)
is mounted to
the empty end of the part of the chain.
Figure 7: Lowering limiter
3.5.10. Load hook
NOTICE
Load hooks may not be loaded at the top. They
may not be directed or annealed. This may result
in damage to the load hook.
If the load hook is bent, your product
PROFI 3 TI
must be inspected.
The permissible temperature range is -40
◦
C (-
40
◦
F) to +150
◦
C (302
◦
F).
Page
16
of 60
Doc.-No.: VA053957-40-OM-EN-0720-60-2
