I N C E P T I O N S H A D E S . C O M
3eight Installation Guide
STEP 1
Remove shade from box. Locate remote, charger, and mounting hardware.
3x - 3/4” screws - for trim/wooden surfaces
3x - 1-5/8” screws - for sheetrock applications (use with anchors)
3x - sheetrock anchors
3x - washers - for ceiling mount applications
1x - charger - compatible with standard USB charging blocks
1x - pre-programmed 1 channel remote
STEP 2
Ensure that shade measurements are as ordered and that shade will fit window as expected.
STEP 3
Apply a piece of painter’s tape to the wall or trim centered above the window opening where the shade is to be mounted.
Draw a line to mark center.
STEP 5
Hold the back mounting plate over the marked line. Use the plate as a guide to mark center screw location on wall or
window trim.
STEP 4
Remove back mounting plate from shade band. Practice clipping and unclipping these components. A solid connection will
be important when it is time to reconnect the band and back plate.
STEP 6
For sheetrock applications
, test to see if there is a stud behind the marked center screw location. Use a stud finder, a 1/16
drill bit, or the mounting screw provided. If no stud is present, screw an anchor into the marked location until it is flush
with the wall surface. Anchors are not necessary when mounting to wooden trim.
For wooden trim
, proceed with Step 7.
