Connect the 24VDC power supply to the
mains (230VAC)
Electrical Connection and Start-up
Helmholtzstrasse 13 Phone +49 (0)781 / 206-0
77652 Offenburg Fax +49 (0)781 / 2 53 18
Werner-von-Siemens-Strasse 12 www.j-schneider.de
77656 Offenburg-Elgersweier info@j-schneider.de
Parameterizing-Software
Shutdown-Software
1.
Connect the C-
TEC
P
to the output of
24VDC power supply
2.
3.
Connect the load to the buffered
24VDC output of the C-
TEC
4.
Wiring of the inputs/outputs
Switch on the power supply.
The C-
TEC
P
is charging.
The LED „Netz/Mains“ illuminate
5.
6.
C-
TEC
is completely charged.
The LEDs „Netz/Mains“ and „U /V
>“
C
cap
illuminate
ATTENTION! The safety notes of the operating instructions have to be regarded.
Installation and wiring work may only be carried out by qualified electricians.
The sheet „Quickstart“ is only a support.
The
TEC
Control-Software automates the system-shutdown at
power failure and the controlled system-restart after
power recovery.
Please ask for further information!
Device parameters such as output voltage, permissible voltage
range, general error a.s.o. can be adjusted with the para
TEC
software.
Please ask for further information!
