J.Sikora – Standard MAX Turntable Manual
23
© 2021 Notable Audio Products | www.notableaudio.com
9.3.
Remove Any Twists on Belt
The easiest way to remove any twists is
to the slowly rotate the Platter with one
hand and use the other hand to untwist
the Belt.
Keep rotating the Platter and removing
any twists until the Belt lays flat against
the Platter.
Removing Twists in Belt
Flat Belt
9.4.
Add Second Belt for Secondary Motor (Left Side)
Repeat Steps 9.1 – 9.3 for the second
Belt on the Secondary Motor. This time,
the Belt goes into the upper groove of
the Pulley.
Two Belts in Position
9.5.
Add Belts for the Primary Motor (Right Side)
Repeat the same Belt installation
process for the Primary Motor that you
used on the right side of the Chassis.
Take one of the Belts and stretch it over
the platter and into the lower groove of
the Pulley.
Next, as with the first two Belts, remove
any twists in the Belt.
Placing Belts on the Primary Motor
When all the Belts are flat, the two Belts
from each Motor will be evenly spaced,
with a larger space between the two
sets of Belts.
All Four Belts In Place