J.Sikora – Standard MAX Turntable Manual
25
© 2021 Notable Audio Products | www.notableaudio.com
10.3.
Install Tall Riser
Place the Tall Riser centered on the
Arm Tower and align the bolt holes of
the Riser and Arm Tower.
Re-insert the three Bolts and securely
tighten with the same Wrench.
Tall Riser Installed
11.
Mount the Primary Armboard
In this step, you will install an Armboard onto the turntable’s Primary Arm Tower.
11.1.
Familiarize Yourself with the Armboard
The Armboard consists of 3 elements:
1) The Connection Pod that mounts
onto the Chassis’s Tonearm Tower.
2) The Arm Pod onto which you attach
your tonearm (tonearm not supplied).
On the side of the Arm Pod there is a Set
Screw for securing a tonearm Insert.
3) The two Connection Rods that
connect the Arm Pod to the Connection
Pod.
Top of Armboard
On the underside of the Armboard, note
that the Connection Pod has a
protruding Mounting Insert that will fit
into the top of the Riser on the Arm
Tower. Also on the underside are two
Set Screws that enable the Arm Bod to
move along the Connections Rods.
Bottom of Armboard
Insert
Set Screw
Connection
Rod
Arm
Pod
Connection
Pod
Arm Pod
Set Screws
Mounting
Insert
