OPERATION
The LaneBlade® wings must be fully
deployed before lowering the
LaneBlade® from its stowed position.
3.
After fully deploying the wings, press and
hold the “DOWN/FLOAT” button on the
controller until the LaneBlade® lowers into
its deployed position. The UNSTOWED light
will illuminate. A quick double-tap of the
DOWN button (or Press & Hold for 3
seconds) will engage the FLOAT mode. The
FLOAT indicator light, located in the center
of the keypad, will change from green to
red.
TO STOW THE LANEBLADE®
The LaneBlade® wings must be fully
extended forward before raising
the LaneBlade® system to its stowed position.
1.
With the wings in their fully deployed
position, double-tap (or Press & Hold for 3
seconds) the UP button to raise the
LaneBlade® into its stowed position.
2.
The UNSTOWED indicator light will
extinguish when the LaneBlade® reaches its
stowed position.
3.
After the LaneBlade® reaches its stored
position, move the wings back by pressing
and holding the “WINGS BACK” button on
the controller until the wings reach their
stowed position (or a double-tap the
WINGS BACK button to engage the function
for 5-6 seconds..
When not pushing road debris, the
LaneBlade® must be raised to its
stowed position. Never operate vehicle on road
with the LaneBlade® deployed unless actively
engaged in removing road debris.
4.
Turn the system off by moving the ON/OFF
SWITCH to OFF.
Always power off the LaneBlade®
when not in use.
5.
Return the controller to its cradle on the
dash.
PARKING WITH THE LANEBLADE®
ATTACHED
Whenever you park your vehicle, completely lower
the LaneBlade® to the ground.
Completely lower the LaneBlade®
to the ground when parking the
vehicle. Keep 8' clear of the LaneBlade® drop
zone.
MOVING DEBRIS WITH THE LANEBLADE®
Every agency will have its own
process to be followed to provide
safety for its unique environment. The following
are the basic steps for removing debris. Always
check with your safety department and local
authorities for vehicle operation and use of the
LaneBlade® in your work zone.
1.
Visually determine likely weight of the
debris. Only attempt to move debris
weighing less than 150lbs.
2.
Press and release the POWER button on the
controller. The STATUS button will flash
indicating the system is on.
3.
Turn on warning and flashing lights to alert
other drivers of your intentions of slowing
down, changing lanes, or any other steps
necessary to remove the debris from
roadway. Frequently check your mirrors
10
