Jabiru Aircraft
Pty Ptd
Installation Manual
Jabiru 2200 Aircraft Engine
REVISION
0 1 2
Dated : March 2006
Page:
37
\\Gateway\library\files\engine_manuals\2200_engine_manuals\Hydraulic_Lifters\Working copies\HL_Installation_Manual_2200_Rev_0.doc
Print Date: 3/8/2006 1:56:00 PM
Figure 13. Coil Cooling Detail #2
21.1 Engine Installation Procedure
Figure 14. Engine Accessory Pack Contents
21.1.1 Procedure:
a) Attach male engine mount rubbers to all engine mount pins on the engine mount.
Place an AN4-31A bolt through each mount (see details below). Note that an engine
mount spacer washer is fitted between the male rubber & the lower engine mount pins
(Refer to Figure below).
b) With the Back of the Aircraft Supported & the wheels chocked, lift the engine onto the
engine mount.
c) Insert the upper engine mount rubbers into the engine backing plate first by tilting the
front of the engine up. Once both upper rubbers are through the engine backing plate,
fit the female rubber, engine mount spacer washer, engine mount washer, ¼” washer
& Heat Proof nut.
Air duct Spring
Rivet
Propeller
guide bush
Washer – engine
mount spacer
Washer –
engine mount
Male rubber
engine mount
Female rubber
engine mount
Lock wire – to
attach ram air
cooling ducts.
Spring mounting bracket
Exhaust
spring
Washer
Belleville washer
