Page No: 66
Issue No: 1
Date: 031100
Issued By: PJA
Note: Make sure outside of tubes are smooth or it will damage the
O Rings.
d)
Oil Push rods and fit.
Note: Make sure ball end of push rod is in the socket of the lifter.
It also helps if the lifter is on the base circle of the lobe.
e)
It is a good ides to fit heads No. 3 & 4 with rocker gear before fitting rest
of heads.
Put loctite 262 on rocker cap screw and torque to 8 ft lbs.
f)
Torque heads to 16 nm then 34 nm (12 ft lbs then 24 ft lbs).
g)
Adjust all valves to 0.25 mm (0.010").
Note: Valves must be adjusted with the lifter 180o to the peak lift
to ensure it is on the base circle.
Sump and Induction
H10 a)
Fit sump using loctite 515 on faces and loctite 242 on threads.
Note:
Because
the
engine
mount plate goes on the sump and
crankcase it is important to make sure the sump is level with
the rear crank case face.
b)
Fit induction pipes to heads before fitting heads.
c)
Fit lower pipes and hoses/later engines S/N 68 on had a bolt on swept
Plenium chamber.
Gear Case and Rear
H11 a)
Insure * Gear case is fitted up
* Backing plate is ready
* All bolts are ready
* Loctite 515
* Loctite 242
* Loctite 262
b)
Turn engine around until it is 25o B.T.D.C. No. 1 compression
c)
Put loctite 515 on crankcase. Fit engine mount plate. Make sure 2
inside cap screws are in. Use loctite 242 on all cap
screws.
d)
Put loctite on gear case and point rotors to No: 1 position.
Summary of Contents for 3300
