Page No: 72
Issue No: 1
Date: 031100
Issued By: PJA
Phillips
Screw
Driver
19)
Fit
Cooling
Ducts
3/16
Allen
Key
20)
Prime Fuel system with electric pump and inspect
for
leaks
21)
Check for oil. Fill if needed.
3.5L oil (3.69 US
quarts)
22)
Wind over to get oil pressure
23)
Start and inspect for leaks
24) Test
Fly
Note: First flight is a test flight so fly conservatively
25)
Remove Cowls and inspect for anything loose, rubbing or leaking.
26)
After 5 and 10 hours and possibly 15 hours retorque heads and adjust valves.
Inspect engine installation.
27)
After 25 hours retorque heads, adjust valves and inspect engine installation.
Change oil and filter. Cut filter open and inspect. Check engine leak down.
28)
If oil consumption is stable fill with W100 (W80 in cold conditions and W120 in
very hot conditions). If it is still using oil remain on W100 oil.
7.6
Prop Strike Inspection
After ground contact of a wooden propeller, check the crankshaft flange for run-out at the
front seal surface. If run-out is evident, the engine will have to be stripped and crankshaft
checked for cracks.
If an engine stoppage due to force is not recorded in the logbook and not advised to
Jabiru, the liability for all subsequent and consequential damage will remain with the
owner. This applies to both prior to and after engine overhaul.
7.7
Build Sheets and Run In Programme
Summary of Contents for 3300
