Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 105 of 233
8.16.4 INSTALLATION
Reverse procedure above for installation.
Loctite 620 must be applied to the assembly screws for the aluminium housing:
-
Clean the threads in the aluminium parts using a ¼” UNC tap.
-
Use compressed air or similar to blow out all blind holes to remove all debris.
-
If re-using hardware, thoroughly clean cap screw threads using a wire wheel or similar to remove
all residual thread retaining compound. If new hardware is being used, thoroughly clean all
threads using aerosol tool cleaner or similar.
-
Apply a bead of Loctite 620 to each screw and to each female thread. Beads should be
approximately the size of a match head.
-
Assemble the parts, using the “solid laminate” torque specified in Table 1.
Ensure fresh nylock nuts are used.
Figure 71
– Machined Nose Leg Housing
8.17 BRAKE MASTER CYLINDER
8.17.1 DESCRIPTION
The brake master cylinder is located either inside the centre console between the seats or on the
front of the main longitudinal beam.
In all models it is actuated by applying rearward pressure to the brake handle.
A small reservoir is incorporated into the master cylinder for the fluid supply.
