Aircraft Technical Manual
Jabiru Aircraft
Pty Ltd
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated: 29th October 2014
Issued By: AS
Page: 246 of 298
11.3 Instrument Panel Mount (all J-Series)
11.3.1 Description
The instrument panel mount is a fibreglass moulding which is secured to the firewall. The instrument
panel fascia secures to this mount and it also supports the panel throttle assembly (where equipped).
11.3.2 Instrument Panel Removal & Installation
Required Tools:
Tools as required in Section 7.1.2 and Section 11.2.2
Parts and Material:
N/A
Type of Maintenance:
Line Maintenance
Level of Certification:
L2 or LAME (A&P or LSA Repairman / Maintenance)
Return to Service:
L2 or LAME (A&P or LSA Repairman / Maintenance)
To remove the fibreglass panel mount from the firewall:
-
Remove the fascia as noted above.
-
Remove the top engine cowl to allow access to the forward side of the firewall.
-
Where equipped, disconnect the panel mount throttle. If required the throttle assembly can
remain inside the panel mount when it is removed
– full disassembly is not necessary.
-
Remove the bolts holding the panel mount to the firewall.
-
Remove the panel mount.
-
Assembly is the reverse of the above procedure.
Figure 186
– Instrument Panel Mount Installation (all J-Series)
