Jabiru Aircraft
Pty Ptd
Aircraft Service Manual
Jabiru J230-C
REVISION
0
Dated : Feb 2006
Issued By: RAS
Page: 58 of 171
L:\files\Technical_manuals\J230_J430\J230.J430_Work_files\J230-C_Tech_Rev_1.doc
Print Date: 14/01/2009 4:41:00 PM
3.
Disconnect flexible brake hose and drain brake fluid.
4.
Remove 4 bolts/nuts/washers securing axle to leg.
NOTE:
When removing axle from leg, note number and position of the wheel alignment
shims (if any) between the axle flange and composite leg. Mark these shims or
tape them together carefully so that they can be installed in exactly the same
position,
to
ensure
that
wheel
alignment
is
not
disturbed.
5.
Remove inboard brake plate.
6.4.6
MAIN WHEEL STUB AXLE INSTALLATION
1.
Secure axle and inboard brake plate to composite leg, making sure that any wheel
alignment shims are installed in their original position.
2.
Install wheel assembly on axle in accordance with Paragraph 6.4.4.
6.4.7
MAIN WHEEL ALIGNMENT
Refer to Figure 13.
6.4.8
WHEEL BALANCING
Since uneven tyre wear is usually the cause of tyre imbalance, replacing the tyre will
probably correct this condition. If a wheel shows evidence of imbalance during service, it
may be statically balanced.
