Signalling
1) Acoustic signalling with the alarm siren
The car alarm informs the user about its status by siren
chirps. The chirps for unsetting, setting and setting with
a triggered input (e.g. open door) can be disabled. Other
chirps cannot be disabled due to their importance.
Warning! If the car alarm has no GSM signal at the time
of setting, it chirps six times. The car alarm is thus unable
to transmit SMS messages and make calls.
2) LED indicator in the car
The LED indicator is used to show
the car alarm status. The table below
describes its individual meanings.
Warning! If the LED indicator starts
fl ashing quickly after the ignition
is switched off, it indicates that there
is no GSM signal and it will not be able
to send any messages or make
a call in the case of an alarm.
Chirps
Meaning
1x
Setting
2x quickly
Partial setting
2x
Unsetting
3x
Unsetting after an alarm
4x
Setting with a triggered input
6x quickly
GSM network is not available
LED state
Meaning
OFF
Unset
Permanently ON
A phone call or connecting to a GSM network
Flashes slowly
Set
Flashes quickly
GSM network is not available or alarm has been
triggered
Interrupted fl ashing
Car blocked (immobilized)
Before switching
the ignition on
Flashing indicates wireless detector activation
After switching
the ignition on
Flashing indicates the number of enrolled cont-
rollers
4
8
T2711 - Jablotron - Manua
́
l Atho8 8
T2711 - Jablotron - Manua
́
l Atho8 8
8.4.2009 13:27:12
8.4.2009 13:27:12