GD-06 ALLEGRO GSM dealer
2/2
MHG51302
3.3. Customization of SMS texts and access
codes
The default texts of reporting SMS and incoming SMS
instruction can be modified using the following programming
SMS:
MASTER TXT index, text
index
index number according to the following
table
text
new text, which will be used in SMS
messages
Basic SMS reports’ texts
Index
Default
Description
10
P1
Description of P1 input terminal
11
On
P1 input terminal is triggered
20
P2
Description of P2 input terminal
21
On
P2 input terminal is triggered
30
P3
Description of P3 input terminal
31
On
P3 input terminal is triggered
40
P4
Description of P4 input terminal
41
On
P4 input terminal is triggered
Basic SMS instructions’ texts
Index
Default
Description
50
P5
Description of P5 output terminal
60
P6
Description of P6 output terminal
70
RELAY
Description of the relay output
100
ON
Instruction to switch on an output
101
OFF
Instruction to switch off an output
109
USER
User access code
110
MASTER
Master access code
You can send multiple texts separated by commas and blank
spaces in one programming SMS.
Examples:
a)
“MASTER TXT 10, Security system, 11, armed”
will
customize the input P1 setting to indicate a security
system’s status. If a corresponding alarm system
output triggers the P1 when arming, then SMS
report “Security system armed” is sent.
b)
“MASTER TXT 71, Heating”
will modify the remote
SMS instruction to switch on a heating system
connected with the relay output to “Heating on”.
c) “MASTER TXT 110, Big elephant”
will change the
master access code to “Big elephant”
4. Operation
After installation of the GD-06
ALLEGRO
and programming
of the telephone numbers, the GD-06 is ready for operation.
•
Triggering of any input P1 to P4 will cause the sending
of a SMS report to the telephones registered in the
positions TEL1 to TEL6.
•
From a GSM phone, you can send an SMS instruction
to switch on or off the P5 and P6 outputs.
•
You can also switch the relay on or off by making a
phone call to the GD-06 from a phone registered to
TEL1 or TEL2 memory positions. The GD-06
ALLEGRO
doesn’t answer this call, so you don’t pay any
telecommunication fee for this remote control.
Notes:
1. You can remotely control the GD-06 from any phone:
not only from the ones stored in the memory TEL1-
TEL6. You just have to add the master (default
MASTER) or user (default USER) access code in front
of the instruction.
Example: “MASTER ON P5”
2. The SMS instructions texts are case insensitive. It
means that instruction
“ON P5”
is equal to
“on p5”
.
5. Advanced programming
More detailed programming can be accomplished from
Internet using the web page
www.gsmlink.cz
. Follow the
product registration instructions to get access to a secure
web page. Use the registration code printed on the warranty
certificate (the code has a form xxxx-xxxxx-xxxx and it is
unique for each system). From the GSMLink, you can
program your GD-06 ALLEGRO easily regardless of where
in the world you are located. The best performance will be
obtained if your SIM card enables GPRS data transmission.
Form the GSMLink server you can:
•
Check the current status of all inputs and outputs
•
Control the outputs
•
Program the GD-06
•
Change the SMS tetxts (only when GPRS data
connection is enabled)
If you don’t have Internet access, you can also use SMS for
the advanced programming. You can find all details in the
Expert programming manual.
