6. Operating the system from an outdoor keypad
If the system is equipped with a JA-80H outdoor keypad or a JA-80N external card
reader, then the outdoor device can be set to work the same way as an indoor
keypad. The system will be set/unset after entering a code (presenting a card).
A more common usage of the outdoor keypad is to open the entrance door:
•
Performing setting or unsetting the system is only possible via an
indoor keypad (or via a key-fob controller).
•
Enter a valid access code or present a valid card to the outdoor
keypad to open the electronic door lock.
If the system is set, and the door is opened via an
outdoor keypad, an entrance delay will begin. During
this delay period the system has to be unset using an
indoor keypad unit (or a key-fob).
7. Panic alarm
If you are in danger you can trigger a silent panic alarm to inconspicuously call
for help. After triggering a panic alarm the system will send voice messages,
SMS messages, and pass data to an alarm receiving centre (central monitoring
station), depending on installation settings. A set system will be unset.
A panic alarm can be triggered as follows:
•
On the keypad
– enter
* 7
before entering an access code (before
presenting a card). If the system has been in a set state, it will be unset =
operation under duress.
•
On the
key-fob
controller – press both
and
buttons simultaneously.
If desired, the controller can be re-configured (by an installer) for Panic
Mode, in which pressing any button will trigger the Panic alarm.
•
By pressing a
large-sized panic button
(that can be installed on a
wall, under a desk etc.).
•
By a
panic code or card
on the keypad.
8. Controlling connected devices from a keypad
The control panel allows you to control various devices in the building, e.g.
heating, air conditioners, ...
(
13.)
and
(
14.)
.
Control can be performed via a
keypad by keying-in the following:
Oasis user manual
8
MKE22102