A split system (
3.)
•
If operation without an access code is enabled
(
4.)
, you only have
to press the A or B button to set (arm) the corresponding section.
Pressing the ABC button results in total setting.
•
If operation without an access code is disabled
(
4.)
and you
perform setting (arming) via an access code or card, then only the
section assigned to the code (card) is set (A, B or ABC).
o
If the code (card) belongs to the whole system (ABC), then it is possible to
set only section A or B by pressing button A or B before entering the code
(card).
•
Using an access code (card) assigned to section C will set the entire
system (ABC). You can also set either section A or B alone – by
pressing the A or B button respectively before you enter a code (or
present a card).
•
By pressing the
button on the key-fob the section to which the
key-fob belongs will be set.
•
When both sections A and B are set, the common section C is set
automatically too
2. During the setting (arming) process …
The system will warn you when anything is going
wrong. Pay attention at the moment of setting to the
information on the keypad.
If the
(
10.)
parameter is enabled, then by displaying “Triggered det.” on the
keypad, the system gives you notice that a detector is triggered (usually a window
or a door is open). By pressing the ? key you will be shown which particular
detector it is. If there are more detectors triggered, you can access them on the
display by pressing (?) repetitively. Naturally, in such situation, it is appropriate to
check through the building and close the doors and/or windows.
If the
(
10.)
parameter is disabled, then
no “Triggered det.” text will be
displayed
. Nonetheless, pressing the ? key lets you display the list of triggered
detectors.
If the
(
11.)
parameter is enabled and “Triggered det.“ is shown on the keypad
display, then after entering an access code (card) or after pressing the A B or
ABC button for quick setting (arming)
you will be offered the possibility of a
bypass
– which means the temporary removal of triggered zones from the
system. If you wish to accept/confirm the bypass suggestion, press *.
If no
confirmation is made, the system will not be set!
The system behaves the
same way when bypassing has been pre-programmed
in maintenance mode
.
Oasis user manual
5
MKE22102