PG-4G
3/2
MEG52202
Description of the setting software PG-4G
Adjusting of the PG-4G set using the software
1. Run PG-4G software and set a new project.
2. Insert the addresses of all cooperating units PG-4G, which can be
found on the paper label sticked onto the transmitter.
3. Insert name / description where the units will be placed.
4. Save the project.
5. Set the correct COM port. Connect PG-4G unit to the power
supply and to the computer. If the connection is successful the
word “Ready…” will appear in the field Status.
6. When the unit, which address has been already filled in is
connected the button “LEARN” will be enabled.
7. By pressing button LEARN all the addresses according to table 4
will be enrolled to the connected unit.
Points 5, 6 and 7 repeat for each unit.
tab. 4 table of the enrolled position of the PG-4G units.
Name of opened
project
To set a new
project
To open the
existing project
To save the
project
To set the
COM port
Address of the
connected PG-
4G unit
Status of the
communication
Status of the
cooperating PG-
4G units
Addresses of the
cooperating PG-
4G units
Button for
configuration of
the connected
PG-4G units
To show the
enrollment table
see tab. 4
To set address
of PG-4G units
Name /
description of
PG-4G units
7.
1.
3.
4.
5.
2.
