29
english
Jabra PrO 9460, 9460-DuO anD 9470 user manual
-
For desk phones without automatic ringtone detection:
In this situation, you will hear your desk phone ring but will not hear a ringtone in your headset or see
a ring indicator on the touchscreen. set the desk phone as the current target by touching the desk phone
icon on the touchscreen or
pressing
the headset’s multifunction button until you hear the desk phone
audio indicator (see also
Section 6.2: The Target Phone Concept
). this is not necessary if you have a gn1000
handset lifter or electronic hookswitch connection that supports ring detection.
-
For all other types of phones:
the base automatically switches the target phone to the one that is ringing, as indicated by the touchscreen
icon and ringtone in the headset. you do not need to change the target manually.
2. Do one of the following to answer the call:
-
For desk phones without automatic ringtone detection:
Open the audio link to the headset by doing one of the following:
tap
the headset’s multifunction button;
touch the call icon on the base touchscreen; or lift the headset from the base (if enabled, see
Section 8.13:
Headset Docking-Operation
). then lift the handset from your desk phone and set it aside or press the desk
phone headset button (if present) to answer the call. (In this case, lifting the headset from its charging
cradle will not open the audio link because the base cannot tell that a phone is ringing.)
-
For all other types of phones and desk phones:
Do one of the following:
Tap
the multifunction button, touch the answer-call icon on the touchscreen or
lift the headset from its cradle.
hanging uP
6.5
Figure 25: Hanging up
to terminate the current call when no calls are on hold, do one of the following:
- For desk phones without a handset lifter or electronic-hookswitch:
Place the desk phone handset back onto its receiver or press the desk-phone headset button (if present) to
terminate the call. then close the audio link to the headset by doing one of the following:
tap
the headset
multifunction button, touch the end-call icon on the base touchscreen, or dock the headset to the base.
- For all other types of phones:
Tap
the headset multifunction button, touch the end-call icon on the base touchscreen, or dock the headset
to the base.
